Prepare the room
Remove only what is safe to remove. Protect the floor, repair the surfaces, and confirm the final dimensions. Locate services and suitable fixing points before drilling.
STEP 6
Take the job in a controlled sequence. Accurate fitting and secure installation matter as much as the finished appearance.
Remove only what is safe to remove. Protect the floor, repair the surfaces, and confirm the final dimensions. Locate services and suitable fixing points before drilling.
Compare the delivery with the current cut list. Check dimensions, drilling, edges, and finish. Label each part and resolve errors before assembly.
Use a reliable level and mark the design references. Plan adjustment for uneven floors and walls; do not copy a crooked ceiling or baseboard as your level line.
Follow the chosen joint and mounting system. Keep units square, level, and plumb. Use the specified wall or floor fixings and required anti-tip restraint. Do not improvise anchor spacing or rely on drywall alone for heavy loads.
Install rods, shelves, hinges, slides, and accessories to their instructions. Check clearances and adjust doors or drawers so they operate freely.
Verify all required fixings and supports, tidy exposed edges, and test movement. Respect the lowest applicable load limit across the panel, support, fastener, and mounting system.
Unknown wall construction, missing fixing points, weak surfaces, or an unclear load path need a suitable installer’s assessment.
Do not force mismatched panels or make unplanned cuts around structural or service obstacles. Recheck the drawing, measurements, and hardware first.
Follow the lighting system instructions. New fixed wiring or changes to circuits should be handled by a qualified electrician under applicable local requirements.
Notes and checkboxes stay on this browser. Copy a backup before clearing browser data.